Battery Explosion-Proof Temperature Cycling Test Chamber 225L
Batteries Ex-Proof Temperature Test chamber, also named as battery climatic chamber, battery explosion proof
environmental chamber, program Explosion proof Test Chamber, High
Low temperature test chamber, battery hot and cold impact testing
machine, is used to test various batteries from 3C products,
automotives, aerospace, transportation, marines, etc.
Battery anti-explosion test chamber, battery explosion proof
testing machine is mainly used for battery environmental test,
electrical test like overcharge, charge and discharge test, and
storage. Depends on the different application, the explosion proof
safety devices are equipped accordingly to EUCAR, or USCAR HL, etc.
Battery ex-proof temperature test chamber technical Specification
| Sanwood Model | SM-225-CB-FB |
| Working volume | 225L |
| Internel size(mm) W*H*D | 600x750x500 |
| External size(mm) W*H*D | about 800x1950x1400 |
| Temperature range | -20℃～100℃ |
| Temperature fluctuation | ±0.5℃ |
| Cooling rate | 1.0～2.0℃/min |
| Heating rate | 2.0～5.0℃/min |
| Temperature uniformity | ±1.0℃ |
| Internal material | SUS304 stainless steel |
| External material | cold-rolled plate,powder coating |
| Heat insulation | polyurethane foam |
| Fan | Centrifugal fan(Impeller Fan) |
| Refrigeration compressor | hermetic compressor |
| Cooling mode | air cooling |
| Refrigerant | R449A |
| Evaporator | finned-tube exchanger |
| Heater | nickel chrome strip heater |
| Working Temperature | +5 ~ 35℃ |
| Power supply | 220V/AC 50Hz |
| Controller | SANWOOD touch screen, programmable controller |
Battery ex-proof temperature test chamber safety devices
1. Standard configuration : ∅100MM pressure relief port, 1 set explosion-prood door chains;
3-color status indicator;
2. Air intake and exhaust device: Intake fresh air and exhaust
harmful gases out.
3. Multipoint temperature monitor system: adopts Sanwood developed
controller, which can be used to acquire surface temperature points
of multiple products
3. C02 fire extinguisher - fire extinguishing system default CO2
cyclinder and spray system, smoke sensor. Manual and automatic
shutoff the fire when chamber the fire extinguishing alarm.
4. C0, H2 gas detector - can detect over 30 types of gases. When
the concentration of any gas over the limit, the system will alarm
and give signal to the chamber.
5. Insulation coating of the inner side walls of the chamber.
6. The control panel is provided with USB or RS232 port, a battery
surface temperature detection display light( will be divided into
three level alarm), a battery fault alarm reminder, a harmful gas
alarm, an exhaust indication light, an emergency stop switch,
outfire indication light and over temperature protection
Corresponding standard:
GB 31241-2014, GB/T 18287 -2013,GB/T 8897.6-2008,YD/T
2366.1-2011,GB/T 21966-2008,
MT/T 1051-2007
IEC 62660, IEC 60082, IEC 61960, IEEE 1625
Product Catalog:
High and Low Temperature Explosion-proof Test Cham...
